d493724a7b
ESP32-S2: Detect EP IN Xfer Timeout
...
In some rare ocasions (bad cable, noise, etc.) data transfer might timeout and hang the endpoint, unless the interrupt flag is cleared.
This pull request targets to solve that case.
2020-07-02 13:05:17 +03:00
4cec866994
correct HSE_VALUE in hal_conf
...
- although it is define in CFLAGS, it is worth to correct to be
consistent with other build
- extract set_speed()
2020-07-02 14:57:00 +07:00
9a290febcd
change default port some stm bsp
...
- f769disco default port is highspeed port1
- remove PORT0 on stlink since the board only populated HS connector
2020-07-02 11:58:40 +07:00
4966fb2e13
clean up
2020-07-02 01:25:21 +07:00
c2289777f7
Merge branch 'add-stm-hs' of github.com:hathach/tinyusb into add-stm-hs
2020-07-01 23:53:33 +07:00
961d813953
Merge pull request #455 from UweBonnes/add-stm-hs
...
Add stm hs
2020-07-01 23:52:27 +07:00
5b3a67a1e2
Add bsp for stlinkv3mini.
2020-07-01 15:42:53 +02:00
196bdbc702
st/synopsys/dcd_synopsys.c: Remove USBC PHY PLL stabilization delay for now
...
While the ST code has a 2 ms stabilization delay for the USBC PHY PLL,
running without this delay showed no problem for at leat 10 USB un/replug
cycles. Observe for problems!
2020-07-01 14:45:07 +02:00
d2450abaaf
only set turnaround in reset complete
2020-07-01 18:51:04 +07:00
e3974d6869
correctly set turn around according to cpu clock
...
help to run with low speed mcu
2020-07-01 18:44:52 +07:00
77315ba7ce
added uart for h743
2020-07-01 18:27:48 +07:00
a512a31c9d
Merge branch 'master' into add-stm-hs
2020-07-01 17:58:02 +07:00
ed1b670c55
clean up code
2020-07-01 17:57:37 +07:00
6178f8de2f
ESP32-S2: Handle the fact that available EP IN FIFOs are less than the number of available EP INs
...
ESP32-S2 has only 5 available endpoint-in FIFOs (including EP0) but 7 available EP IN numbers. This change decouples the fifo number from the endpoint number, providing FIFO numbers until they reach the limit, at which point it will return false and assert an error that too many endpoints were allocated.
2020-07-01 13:38:59 +03:00
0c9932440b
Merge pull request #452 from hathach/fix-dfu-rt
...
Fix dfu rt
2020-07-01 15:24:39 +07:00
ea67aee75b
Update README.md
2020-07-01 13:19:06 +07:00
530b0099a5
Merge pull request #439 from UweBonnes/add-stm-hs
...
Add stm hs
2020-07-01 13:09:07 +07:00
383f8047a5
Merge pull request #453 from hathach/add-da14695-usb
...
Add da14695 usb
2020-07-01 13:02:16 +07:00
463e978134
added DA14695 DK USB bsp
2020-07-01 12:47:14 +07:00
2f946e765d
rename file
2020-07-01 12:42:12 +07:00
12a145b27d
fix dfu-rt to response to SET_INTERFACE and DFU_GETSTATUS
...
fix #450
2020-07-01 01:33:02 +07:00
e4391c32a6
Merge pull request #451 from duempel/fix_synopsys_short_packet
...
Fix receiving of short packet data (Synopsys)
2020-07-01 00:11:21 +07:00
400c2d2e50
correct led dfu_rt example
...
also add example usage note
2020-06-30 23:26:51 +07:00
378e6aab8c
Clear ep0_pending if rx short packet
2020-06-30 17:56:25 +02:00
9e35ef73f7
Fix receiving of short packet data (ep out)
2020-06-30 12:55:39 +02:00
0477446224
more clean up
2020-06-30 16:31:59 +07:00
f3a88477dc
revert rhport config in nxp mcus
2020-06-30 16:18:43 +07:00
30a18e2605
stm32f723disco: USB HS enumerates.
2020-06-30 11:07:53 +02:00
62239bb576
cdc-acm: Use 512 bytes when in HS mode.
...
Removes error:
config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64
while enumerationg.
2020-06-30 11:02:41 +02:00
05bfd9ac4a
dcd_synopsys: Handle HS and FS IP in one device
...
FIXME: Allow run-time selection to allow to handle both HS and FS with
one file
F746 HS port enumerates with error
config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64
2020-06-30 11:02:41 +02:00
f6660c39a1
Add Stm32F7xxdisco board support files
...
Status with examples/device/cdc_msc:
- make BOARD=stm32f723disco => OK
- make BOARD=stm32f723disco PORT=1 => No Reaction
- make BOARD=stm32f746disco => OK
- make BOARD=stm32f746disco PORT=1 => Hangs during enumeration
- make BOARD=stm32f769disco => Hangs during enumeration
2020-06-30 11:02:38 +02:00
4b7f848e1f
stm32h743nucleo: Enable Log via STLINK-VCP.
2020-06-30 11:01:44 +02:00
ab75998316
Merge branch 'master' into add-stm-hs
2020-06-30 01:55:57 +07:00
05996aee64
Merge pull request #427 from kasjer/kasjer/add-da1469x-support
...
Support for DA1469x MCU from Dialog Semiconductor
2020-06-30 01:20:56 +07:00
2b9466dbc0
Merge pull request #445 from hathach/add-kaluga-bsp
...
added esp32s2 kaluga bsp
2020-06-29 19:16:09 +07:00
2dff40236c
add kaluga files
2020-06-29 18:40:23 +07:00
00104894dc
update ci
2020-06-29 18:07:34 +07:00
50b569ad1b
added esp32s2 kaluga bsp
2020-06-29 16:52:08 +07:00
268ab9eaa8
Merge pull request #399 from duempel/redesign_synopsys_receive
...
Improvements to Synopsys EP OUT
2020-06-29 16:02:40 +07:00
8e143fc962
Add board support for Dialog DA1469x-dk-pro
...
This adds source files that allow to run TinyUSB stack on DA1469x-dk-pro board.
Source files .c .S and .ld are taken from Apache Mynewt repository.
Those files were stripped to allow starting board without Mynewt os.
2020-06-29 11:02:32 +02:00
99df7789a7
Add author name to dcd_synopsys.c
2020-06-29 10:55:03 +02:00
530bc2c39c
Add name to contributor list
2020-06-29 09:57:17 +02:00
4f69bcea7e
Remove EP0 remaining bytes manipulation
...
Renaming edpt_xact to edpt_schedule_packets
2020-06-26 17:18:25 +02:00
562c079cf4
Merge pull request #444 from jepler/same5x_bugfix
...
dcd_samd: Provide implementation for OPT_MCU_SAME5X
2020-06-26 14:40:57 +07:00
b2ef8cdd42
dcd_samd: Provide implementation for OPT_MCU_SAME5X
2020-06-25 18:51:04 -05:00
d489581deb
Merge pull request #441 from hathach/add-same5x
...
added OPT_MCU_SAME5X option
2020-06-26 01:31:39 +07:00
504b152f88
update readme
2020-06-26 01:30:33 +07:00
d5bfb70b72
Merge pull request #442 from czeslawmakarski/pr/update-nrfx-to-nrfx-2.2.0
...
Update NRFX to v2.2.0
2020-06-25 13:45:27 +07:00
7c94176b4b
Update NRFX to v2.2.0
2020-06-24 15:07:28 +02:00
d4d6e06c1d
added OPT_MCU_SAME5X option
2020-06-24 00:53:17 +07:00
me-no-dev