onewire_master: set project specific config
This commit is contained in:
parent
b9b9eea2a0
commit
4ade159586
|
@ -29,13 +29,13 @@
|
||||||
* @note external pull-up resistor on pin is required (< 5 kOhm)
|
* @note external pull-up resistor on pin is required (< 5 kOhm)
|
||||||
* @{
|
* @{
|
||||||
*/
|
*/
|
||||||
#define ONEWIRE_MASTER_PIN PC9 /**< GPIO pin */
|
#define ONEWIRE_MASTER_PIN PB8 /**< GPIO pin */
|
||||||
/** @} */
|
/** @} */
|
||||||
|
|
||||||
/** @defgroup onewire_master_timer timer used to measure 1-wire signal timing
|
/** @defgroup onewire_master_timer timer used to measure 1-wire signal timing
|
||||||
* @{
|
* @{
|
||||||
*/
|
*/
|
||||||
#define ONEWIRE_MASTER_TIMER 5 /**< timer ID */
|
#define ONEWIRE_MASTER_TIMER 3 /**< timer ID */
|
||||||
/** @} */
|
/** @} */
|
||||||
|
|
||||||
/** set if the timer ISR should be set in the interrupt table instead of the vector table
|
/** set if the timer ISR should be set in the interrupt table instead of the vector table
|
||||||
|
|
Loading…
Reference in New Issue