espressif_tinyusb/hw/bsp/ea4088qs/board.mk

48 lines
1.1 KiB
Makefile

CFLAGS += \
-mthumb \
-mabi=aapcs \
-mcpu=cortex-m4 \
-nostdlib \
-DCORE_M4 \
-DCFG_TUSB_MCU=OPT_MCU_LPC40XX \
-DCFG_TUSB_MEM_SECTION='__attribute__((section(".data.$$RAM2")))' \
-D__USE_LPCOPEN
# mcu driver cause following warnings
CFLAGS += -Wno-error=strict-prototypes -Wno-error=unused-parameter
MCU_DIR = hw/mcu/nxp/lpc_driver/lpc40xx/lpc_chip_40xx
# All source paths should be relative to the top level.
LD_FILE = hw/bsp/ea4088qs/lpc4088.ld
# TODO remove later
SRC_C += src/portable/$(VENDOR)/$(CHIP_FAMILY)/hal_$(CHIP_FAMILY).c
SRC_C += \
$(MCU_DIR)/../gcc/cr_startup_lpc40xx.c \
$(MCU_DIR)/src/chip_17xx_40xx.c \
$(MCU_DIR)/src/clock_17xx_40xx.c \
$(MCU_DIR)/src/gpio_17xx_40xx.c \
$(MCU_DIR)/src/iocon_17xx_40xx.c \
$(MCU_DIR)/src/sysctl_17xx_40xx.c \
$(MCU_DIR)/src/sysinit_17xx_40xx.c \
$(MCU_DIR)/src/uart_17xx_40xx.c
INC += \
$(TOP)/$(MCU_DIR)/inc
# For TinyUSB port source
VENDOR = nxp
CHIP_FAMILY = lpc17_40
# For freeRTOS port source
FREERTOS_PORT = ARM_CM3
# For flash-jlink target
JLINK_DEVICE = LPC4088
JLINK_IF = swd
# flash using jlink
flash: flash-jlink