espressif_tinyusb/hw/bsp/ea4357/board.mk

46 lines
998 B
Makefile

CFLAGS += \
-flto \
-mthumb \
-mabi=aapcs \
-mcpu=cortex-m4 \
-nostdlib \
-DCORE_M4 \
-DCFG_TUSB_MCU=OPT_MCU_LPC43XX \
-D__USE_LPCOPEN
# mcu driver cause following warnings
CFLAGS += -Wno-error=unused-parameter -Wno-error=strict-prototypes
MCU_DIR = hw/mcu/nxp/lpcopen/lpc43xx/lpc_chip_43xx
# All source paths should be relative to the top level.
LD_FILE = hw/bsp/ea4357/lpc4357.ld
SRC_C += \
$(MCU_DIR)/../gcc/cr_startup_lpc43xx.c \
$(MCU_DIR)/src/chip_18xx_43xx.c \
$(MCU_DIR)/src/clock_18xx_43xx.c \
$(MCU_DIR)/src/gpio_18xx_43xx.c \
$(MCU_DIR)/src/sysinit_18xx_43xx.c \
$(MCU_DIR)/src/i2c_18xx_43xx.c \
$(MCU_DIR)/src/i2cm_18xx_43xx.c \
$(MCU_DIR)/src/uart_18xx_43xx.c
INC += \
$(TOP)/$(MCU_DIR)/inc \
$(TOP)/$(MCU_DIR)/inc/config_43xx
# For TinyUSB port source
VENDOR = nxp
CHIP_FAMILY = transdimension
# For freeRTOS port source
FREERTOS_PORT = ARM_CM4
# For flash-jlink target
JLINK_DEVICE = LPC4357
JLINK_IF = jtag
# flash using jlink
flash: flash-jlink