ISO endpoints were not covered so far by the driver code.
This adds support for ISO IN and OUT endpoint handling.
Registers for ISO IN(OUT) endpoints are placed just after normal IN(OUT)
so in some cases common code could be used for handling all type of
transfers.
Generally code synchronizes ISO endpoint handling to SOF interrupt.
This code does not change the way of how non-ISO endpoints are treated.
Code uses strategy outlined in nRF52840 Produce Specification v1.0
sections 6.35.11.1 and 6.35.11.2.
Closing endpoints can be important when there are alternate
instances. This adds functionality of closing endpoints
similar to what exists in other drivers.
Operator < used in while condition was obviously incorrect.
Loop starts with checking if unsigned variable is less then 0.
This condition is always false.
This reverses condition to follow intention of of the code.
Endpoint close was implemented only in one driver so far.
This function is needed for interfaces with several alternate settings.
The way FIFO is allocated in dcd_edpt_open() allows to correctly close
only one IN endpoint (the one that was opened last).
Wrong FIFO was flushed in dcd_edpt_stall().
(epnum - 1) should only be used when accessing DIEPTXF registers.
For DIEPCTL and GRSTCTL epnum is correct index.
For ISO endpoint driver has to specify when data
is to be transmitted (odd or even frame).
Currently code was not updating this bit resulting in
data being sent every other frame.
If interval was 1ms full data packed was sent every 2ms, and
ZLP was sent in between.
In some rare ocasions (bad cable, noise, etc.) data transfer might timeout and hang the endpoint, unless the interrupt flag is cleared.
This pull request targets to solve that case.
While the ST code has a 2 ms stabilization delay for the USBC PHY PLL,
running without this delay showed no problem for at leat 10 USB un/replug
cycles. Observe for problems!
ESP32-S2 has only 5 available endpoint-in FIFOs (including EP0) but 7 available EP IN numbers. This change decouples the fifo number from the endpoint number, providing FIFO numbers until they reach the limit, at which point it will return false and assert an error that too many endpoints were allocated.
FIXME: Allow run-time selection to allow to handle both HS and FS with
one file
F746 HS port enumerates with error
config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64
Ha Thach