board/CHANGELOG.md

v0

this version has been designed to fit in a 100x60x25mm enclosure. this makes it very compact, and not all surface mount parts fit on one side. this is not too much of an issue since it's a hand soldered prototype.

the prototype mostly works, with a couple of small errors:

• 6-40V power input is not activated unless the hub is already powered (through USB or 5V input)
• crystal oscillator doesn't always start. I think the underlying copper plane skewed the impedance/capacitance too much
• USB-A footprint has inverted pinout: just solder it on the other side and don't swap the data pins in the EEPROM configuration
• fuse on downstream port is not fast enough to prevent shorts and causes the hub to reset
• 6-40V power input capacitor is too tall and does not fit in the case
• one of the LEDS on port 3 is misplaced