doc: improve usage, and mention ES600 limitation
This commit is contained in:
parent
a66295f754
commit
1a17402b74
15
README.md
15
README.md
|
@ -9,18 +9,23 @@ this connector allows the RPH0002 battery to be used a standalone, independently
|
|||
usage
|
||||
=====
|
||||
|
||||
plug the connector in either way since it's reversible.
|
||||
toggle the switch to on, and the nearby red LED should light up.
|
||||
plug the connector at the bottom of the battery either way since it's reversible.
|
||||
toggle the switch to on, and the green RUN LED should light up.
|
||||
the strobing blue ACT LED shows the board is communicating with the battery.
|
||||
you are ready to use the battery.
|
||||
use the XT60 connector to easily connect wires to the battery.
|
||||
the XT60 connector allows easily connecting wires to the battery.
|
||||
|
||||
use the DC barrel jack connector (5.0 mm OD, 2.1 mm ID) to charge the battery.
|
||||
the charger should be for a 13S battery pack, up to 54.6V, and 5A.
|
||||
when charging, the % should blink, and the charging level displayed.
|
||||
the charger should be for a 13S battery pack, up to 54.6V, and maximum 5A.
|
||||
when charging, the red LED next to the connector should turn on.
|
||||
on the battery display the % should blink, and the charging level displayed.
|
||||
|
||||
when the switch is toggled to off, the battery light turns red.
|
||||
this clears after 10 minutes.
|
||||
|
||||
currently it can only operate the batteries for the ES400B.
|
||||
the hardware supports the ES600, but not the firmware yet.
|
||||
|
||||
mode of operation
|
||||
=================
|
||||
|
||||
|
|
Loading…
Reference in New Issue