53 lines
1.9 KiB
Raw Permalink Normal View History

2022-11-13 15:58:20 +01:00
first production batch.
redrawn in KiCAD.
removed debug pins.
2022-05-18 17:31:17 +02:00
second prototype built.
needs a couple of small fixes, but works much better.
fixes (from v0):
- an LDO replaces the zener diode as voltage reference
- the voltage reference (2.1V) is below common-mode input-voltage range
- USB-C plug tab mounting holes made larger
- quad op-amp instead of dual op-amp is used
- other 2 op-amp circuits are used to indicate over-voltage using an LED
- more compact dual common-cathode diodes are used
- no decoupling caps around LDO
- no clearance around USB-C receptacle mount holes, causing the non-plated hole to be fabbed plated, and shorting ground to internal layers
2022-04-08 10:58:31 +02:00
first prototype, with pin header to debug
the over-voltage protection is based on an design described by Texas Instruments, in Analog Engineer's Circuit: Amplifiers, SNOAA20, Overvoltage protection with comparator circuit.
this design is not ideal for our case though.
a Zener diode is used as reference voltage.
it requires at least 1 mA to operate.
this is already a lot for my application.
but 1 mA is when VBUS is at it's minimum of 4.75V.
at 35V this would result in 21 mA.
this power is mainly dissipated by the resistor limiting the current going through the diode.
the dissipated ~0.6W exceeds the 0.1W rating of the resistor, also heating up a zone of the board to 100 °C.
the reference voltage is current dependent, thus the cutoff voltage goes above 5.5V.
this is not too much of a problem because VBUS also exceeds this voltage, but it's not ideal.
design errors:
- the footprint for the USB-C plug has too small mounting holes
- the LM393 is actually an open-collector comparator, but the circuit uses it as push-pull
- the zener diode needs at least 1 mA to be used as voltage reference, not 10 µA (Ileakage and Ibias/Ikz are mixed)
- the design does not respect the common-mode input-voltage range (up to Vcc-2)